We want to deploy an ASA 5510 to replace an ISA 2004 server.

Currently, on the internal side of the ISA, we have multiple web servers, a few FTP servers, etc. On the external side, the ISA is bound to multiple real internet IP addresses.

Since our knowledge on ASA 5510 is next to none:

1. Can the ASA 5510 be bound to multiple IP addresses on one interface (that would be the one being assigned external)?

2. I am assuming the ASA 5510 can be configured to pass web/ftp/etc requests traffic from the outside to the servers on the inside.

Info of the ASA:

Cisco Adaptive Security Appliance Software Version 8.0(2)

Device Manager Version 6.0(2)

Compiled on Fri 15-Jun-07 19:29 by builders

System image file is "disk0:/asa802-k8.bin"

Config file at boot was "startup-config"

ciscoasa up 20 hours 28 mins

Hardware: ASA5510, 256 MB RAM, CPU Pentium 4 Celeron 1600 MHz

Internal ATA Compact Flash, 256MB

BIOS Flash M50FW080 @ 0xffe00000, 1024KB

Encryption hardware device : Cisco ASA-55x0 on-board accelerator (revision 0x0)

Boot microcode : CN1000-MC-BOOT-2.00

SSL/IKE microcode: CNLite-MC-SSLm-PLUS-2.01

IPSec microcode : CNlite-MC-IPSECm-MAIN-2.04

0: Ext: Ethernet0/0 : address is 001e.7a36.626a, irq 9

1: Ext: Ethernet0/1 : address is 001e.7a36.626b, irq 9

2: Ext: Ethernet0/2 : address is 001e.7a36.626c, irq 9

3: Ext: Ethernet0/3 : address is 001e.7a36.626d, irq 9

4: Ext: Management0/0 : address is 001e.7a36.6269, irq 11

5: Int: Internal-Data0/0 : address is 0000.0001.0002, irq 11

6: Int: Internal-Control0/0 : address is 0000.0001.0001, irq 5

Licensed features for this platform:

Maximum Physical Interfaces : Unlimited

Maximum VLANs : 100

Inside Hosts : Unlimited

Failover : Active/Active

VPN-DES : Enabled

VPN-3DES-AES : Enabled

Security Contexts : 2

GTP/GPRS : Disabled

VPN Peers : 250

WebVPN Peers : 50

Advanced Endpoint Assessment : Disabled

This platform has an ASA 5510 Security Plus license.