Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
236
Views
0
Helpful
1
Replies

RighFax Problem at configuration

dbenattou
Level 1
Level 1

‎06-18-2008 08:18 AM - edited ‎03-15-2019 11:22 AM

hello,

i have installed the RF9.3 and i have licensed it, the brooktrut is also installed, the email gateway is configured.

I don't know what's the next steps that i must do to success the delivery of faxes.

Thanks at advance

Labels:
0 Helpful
1 Reply 1

Tommer Catlin
VIP Alumni
VIP Alumni

‎06-18-2008 08:26 AM

Sounds like you need to route the DIDs to the brooktrout board right? Is board a T1 or ? Im thinking your board is a T1 card in your RF server. With that in mind, you will connect it your Cisco Router on a T1 card. You will route the incoming DIDs from the PRI through MGCP or H323 back through the T1 card connected to the Brooktrout card. The RF will answer, read the fax, route it to the Exchange mailbox.

Do you have all the installation documentation for the RF server?

0 Helpful
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Customers Also Viewed These Support Documents