06-18-2008 08:18 AM - edited 07-03-2021 04:02 PM
hi,
my name is Filippo...i'm a new user..sorry for my english. I have a problem with 2 aironet 1310 in role root and non root without configuring VLAN because i must associate other bridge 350 on root station.
the question is: i'm unable to ping host whit different VLAN1 assigned to interface BVI1. the radio schema is:
Switch2----BRIDGE Root<--->BRIDGE non-root--Switch1 VLAN1..VLAN172
Switch1:
interface FastEthernet0/46
description to bridge non-root
switchport trunk allowed vlan 1,2,60,70
switchport mode trunk
no snmp trap link-status
spanning-tree portfast trunk
end
BRIDGE non-root:
dot11 ssid kerberosisa
authentication open
guest-mode
infrastructure-ssid optional
!
bridge irb
!
!
interface Loopback0
no ip address
no ip route-cache
!
interface Dot11Radio0
no ip address
no ip route-cache
!
encryption key 1 size 128bit 7 SECURE transmit-key
encryption mode wep mandatory
!
ssid kerberosisa
!
station-role non-root bridge
world-mode dot11d country IT both
bridge-group 1
!
interface FastEthernet0
no ip address
no ip route-cache
full-duplex
bridge-group 1
!
interface BVI1
ip address 10.1.1.101 255.255.255.0
no ip route-cache
!
ip default-gateway 10.1.1.1
ip http server
ip http secure-server
bridge 1 protocol ieee
bridge 1 route ip
BRIDGE root:
dot11 ssid kerberosisa
authentication open
bridge irb
!
!
interface Dot11Radio0
no ip address
no ip route-cache
!
encryption key 1 size 128bit 7 SECURE transmit-key
encryption mode wep mandatory
!
ssid kerberosisa
!
station-role root bridge
world-mode dot11d country IT both
bridge-group 1
!
interface FastEthernet0
no ip address
no ip route-cache
full-duplex
bridge-group 1
!
interface BVI1
ip address 10.1.1.103 255.255.255.0
no ip route-cache
!
ip default-gateway 10.1.1.1
ip http server
ip http secure-server
bridge 1 protocol ieee
bridge 1 route ip
Switch2:
interface FastEthernet0/1
description Bridge Root
switchport mode trunk
spanning-tree portfast trunk
end
IOS ver. 12.3(2)JA4
the command 'sh spanning-tree root ' on BR-root is correct
Bridge group 1
Root ID Priority 32768
Address 0011.21f8.5700
Cost 59
Port 6 (Virtual-Dot11Radio0)
Hello Time 2 sec Max Age 20 sec Forward Delay 15 sec
non-root
Bridge group 1
Root ID Priority 32768
Address 0011.21f8.5700
Cost 26
Port 3 (FastEthernet0)
Hello Time 2 sec Max Age 20 sec Forward Delay 15 sec
is ok!
any idea? please...
TKS
06-26-2008 03:15 AM
hi,
You must configure trunk on ethernet and dot11 interfaces on access point too, not only on switches. Now is bridged VLAN 1 (native) only
regards
romek
06-26-2008 06:58 PM
step one is to use the GUI on hte AP to configure the VLAN you can do it wiht the CLI but it is alot of typing.
Here is the document that explains it bpth ways
HTH
Bill
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: