06-19-2008 03:37 AM - edited 03-03-2019 10:25 PM
Hi,
when you need to debug an acl on a router does the acl have to be applied to the interface?
06-19-2008 04:02 AM
I usually apply the ACL under interface, remember permit ip any any at the end.
HTH
Sam
06-19-2008 04:04 AM
OK but does it have to be applied to the interface
06-19-2008 04:10 AM
yes, it where it will clock up packets u need to debug.
be as specific as u can so u dont overwhelm the router with debug.
have the "u all" (short for undebug all) command ready to be entered in case router shows slow response.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: