cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
410
Views
0
Helpful
3
Replies

Easy question on debuging acl's

agent2007
Level 1
Level 1

Hi,

when you need to debug an acl on a router does the acl have to be applied to the interface?

3 Replies 3

cisco_lad2004
Level 5
Level 5

I usually apply the ACL under interface, remember permit ip any any at the end.

HTH

Sam

OK but does it have to be applied to the interface

yes, it where it will clock up packets u need to debug.

be as specific as u can so u dont overwhelm the router with debug.

have the "u all" (short for undebug all) command ready to be entered in case router shows slow response.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Innovations in Cisco Full Stack Observability - A new webinar from Cisco