Fast Busy when sending calls over Intercluster Trunk to PSTN

Unanswered Question
Jun 19th, 2008
User Badges:

I have CCM6.1(2) setup in a lab w/ a Intercluster trunk connecting to our Production 4.2(3)environment. I can place calls back and forth between the two clusters over the ICT so the trunk is working, but I cannot place calls from the lab to PSTN via the ICT. I see the calls on the H323 gateway, but I get a fast busy on the phone. A debug on the H323 Gateway shows this:


Cause i = 0x80AC - Requested circuit/channel not available


Any ideas? Thanks.

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Chris Deren Thu, 06/19/2008 - 11:18
User Badges:
  • Super Silver, 17500 points or more
  • Hall of Fame,
  • Cisco Designated VIP,

    2017 IP Telephony, Contact Center, Unified Communications

Can you post the entire "debug isdn q931".



Chris

Chris Deren Thu, 06/19/2008 - 12:28
User Badges:
  • Super Silver, 17500 points or more
  • Hall of Fame,
  • Cisco Designated VIP,

    2017 IP Telephony, Contact Center, Unified Communications

You are sending 10 digits "2027115911" is this what you want? Is 10 digit dialing allowed in this area code? What happens when you send the call as 7 or 11 digits?


Chris

d-roush Thu, 06/19/2008 - 12:33
User Badges:

Yes. In the DC Area, you can send out 7, 10 & 11 Digits. I have dial-peers setup on the voice gateway for all 3. Sening out 7 digits gets the same result.

Actions

This Discussion