Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
748
Views
0
Helpful
4
Replies

Another issue with DFM

dionjiles
Level 1
Level 1

‎06-19-2008 09:20 AM

I have a VPN Firewall (Cisco PIX 520)

all looks good with the device it is being managed by RME, IPM, DFM and CM, however this device is not generating CiscoWork notifications when it goes offline, we had to reboot the device this morning.

What should I look for to make sure this device is configured properly.

Labels:
0 Helpful
4 Replies 4

Joe Clarke
Cisco Employee
Cisco Employee

‎06-19-2008 11:16 AM

First, make sure the PIX is in a Known state within DFM. Next, check the Reachability Settings polling period for this device (or device class) under DFM > Configuration > Polling and Thresholds > Polling Parameters. Make sure you're polling often enough to catch the reload.

0 Helpful

dionjiles
Level 1
Level 1
In response to Joe Clarke

‎06-19-2008 11:27 AM

Hi,

I just checked the device in DFM it is in a known state and as far as the polling parameters everything is at default. Should I change the Reachability settings or something?

0 Helpful

Joe Clarke
Cisco Employee
Cisco Employee
In response to dionjiles

‎06-19-2008 11:29 AM

You might try dropping the reachability polling from four minutes to say, two minutes.

0 Helpful

dionjiles
Level 1
Level 1
In response to Joe Clarke

‎06-19-2008 11:49 AM

I will do make this change now......thanks for the help.

0 Helpful
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Customers Also Viewed These Support Documents