protocol/port usage per interface

Unanswered Question
Jun 20th, 2008


Are there any commands that will show the percentage (or something along those lines) of useage of protocols and ports on a ciso pix's interface.

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
somanyholes Fri, 06/20/2008 - 05:08

Hi Happs

Thanks for the response. Unfortunately I am not able to extract any information from the pix, so syslog/snmp etc are out of the equation. I only have the cli to use. Have a feeling this is not going to be possible.


michael.leblanc Fri, 06/20/2008 - 07:13


Would the PIX have NetFlow commands equivalent to the following, which are available in the IOS?

ip flow-top-talkers

top 25

sort-by packets

show ip flow top-talkers

... if so, he could derive "some" of the benefits of NetFlow via the CLI output.


This Discussion