06-23-2008 10:43 AM - edited 03-11-2019 06:03 AM
In a active/standby config, should I use a hardwired cross-connection between them or a separate switch between them. How about in a active/active config? Thanks
06-23-2008 11:01 AM
According to the configuration guide, you should either use the failover cable (special cable) or the LAN.
http://www.cisco.com/en/US/products/ps6120/products_configuration_example09186a0080834058.shtml
Hope that helps.
06-30-2008 06:30 PM
Use the failover cable. It was designed for a reason.
06-30-2008 10:28 PM
special cable was designed for PIX not for ASA.
on ASA you should do LAN based failover.
http://www.cisco.com/en/US/docs/security/asa/asa72/configuration/guide/failover.html
07-01-2008 02:34 AM
Dear,
Best way is to use a switch or dedicated vlan.
Regards,
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: