Can't make calls with video dial-peer

Unanswered Question
Jun 24th, 2008
User Badges:

I want to establish videoconferences using a cisco 7985 against an external system. At first I thought that I had problems with numbers that belonged to video peers, but then I realized that it was the same with normal peers, but always that I used this dial-peer.


The dial-peer that I'm using is:



dial-peer voice 100 pots


destination-pattern 70.%


information-type video


incoming called-number 91732XXXX


bandwidth maximum 128 minimum 128


port 0/0/1:15


forward-digits 9


!


dial-peer voice 101 voip


destination-pattern 70.%


voice-class codec 2


session target ipv4:10.252.a.b


incoming called-number 7091837YYYY


!



When the call is made, it shows this disconnection cause:



Jun 23 18:23:43.539: ISDN Se0/0/1:15 Q931: RX <- DISCONNECT pd = 8 callref = 0x0043


Cause i = 0x80AF - Resource unavailable, unspecified


Display i = 'RECURSOS NO DISPONIBLES'


….


Call Entry(Disconnect Cause=47, Voice Class Cause Code=0, Retry Count=0)



If followed a guide to configure this dial-peer, but obviously I did something wrong. I think it may be related with the primary and secondary channels, but I'm not really sure how to configure them.



Any idea it could work?? I will appreciate any kind of help. I attach the configuration file and a trace file. Thank you very much.



  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Marwan ALshawi Tue, 06/24/2008 - 21:04
User Badges:
  • Purple, 4500 points or more
  • Community Spotlight Award,

    Best Publication, December 2015

i think you have to put the bandiwdith duble

for example u have put it like 128 try to make it 256

also if you have deffrent codec in use check XCODING resources


good luck

Chad Stachowicz Tue, 06/24/2008 - 21:27
User Badges:
  • Silver, 250 points or more

for Voice, XCODER resources will not be invoked using voice-class codec X.


Dial-peers must be set hard! (i.e. codec g711ulaw)..



Chad

luz.mata Wed, 06/25/2008 - 06:47
User Badges:

I am working on the same issue and I have upgraded the bandwith to 256 kbps, removed the voice-class codec from the dial-peer and established codec g77ulaw as the unique codec, but it is still not working. Any other idea that we could try??


Thank you very much!!!

luz.mata Wed, 06/25/2008 - 07:06
User Badges:

Now the dial-peers are this way:


!

dial-peer voice 100 pots

destination-pattern 70.%

information-type video

incoming called-number 917328040

bandwidth maximum 256 minimum 256

port 0/0/1:15

forward-digits 9

!

dial-peer voice 101 voip

destination-pattern 70.%

session target ipv4:10.252.100.11

incoming called-number 70918379060

codec g711ulaw

!

!


Alberto

Actions

This Discussion