IPSEC Tunnel between JUNIPER (SSG 20) and CISCO PIX 501

Unanswered Question
Jun 24th, 2008

I have successfully established the IPSEC tunnel with juniper firewall by using cisco Pix 501 (6.3 version). The problem I am facing, I have network layer connectivity but after time interval I am not able to send the traffic on destination IP address on specific port, but can successfully PING the destination IP. On both firewalls the IPs are permitted for all ports.

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.

Actions

This Discussion