06-25-2008 12:47 AM - edited 03-15-2019 11:30 AM
Hello,
I have connected a PBX ericsson BP 250 to an FXO in my voice enabled router 2811.
The problem is:
When an analog phone attached to the PBX calls an IP phone registred with the CME, the IP phone ring normally. But when the analog phone goes on-hook, the IP phone continues to ring.
Please can you help me.
Thank you very much.
Solved! Go to Solution.
06-26-2008 02:07 AM
Hi, these should be CPTs for Tunisia:
http://www.3amsystems.com/wireline/tone-search.htm?start=0&kCountry=177&kTone=&frequency=&cadence=
Check if your PBX is actually using one of these.
06-25-2008 01:34 AM
Hi, are are you using the keyword "opx" in connection plar" ? You need that.
Then if that is not enough you need to configure disconnect supervision, likely based on tones:
http://www.cisco.com/en/US/tech/tk652/tk653/technologies_tech_note09186a00800ae2d1.shtml
Hope this helps, please rate post if it does!
06-25-2008 01:41 AM
Thank you very much mr Bevilacqua
I need to khnow this two parameters:
-frequency
-cadence
of the PBX BP-250
Thank you very much
Houichi Nizar
06-25-2008 01:57 AM
Have tried OPX first ?
For the parameters, set cptone as per you country under voice port. That may be enough.
06-25-2008 02:04 AM
Hello,
I don't need a connection plar. So i don't tried opx.
Thank you
06-25-2008 02:05 AM
So how do you route the call to a specific phone, are you using IVR or what ?
06-25-2008 02:14 AM
Hello,
I'm using extension. I call the number of port thet connect the PBX to the FXO. Then i dial the number of IP phone.
Tahnk you
06-25-2008 03:21 AM
Then yes you need supervisory disconnect. If the default doesn't work, tell us which country are you in, record the tones with a PC and attach the file here.
06-26-2008 12:42 AM
hello,
thank you first for your assistance.
I'm from tunisia and i use a pbx Ericsson BP 250
in a central office. I would like to khnow the parametres of this command:
voice class custom-cptone Discon
dualtone disconnect
frequency 425
cadence 500 500
Thank you very much.
06-26-2008 02:07 AM
Hi, these should be CPTs for Tunisia:
http://www.3amsystems.com/wireline/tone-search.htm?start=0&kCountry=177&kTone=&frequency=&cadence=
Check if your PBX is actually using one of these.
06-26-2008 03:19 AM
thank you very very much
my problme is resolved
06-26-2008 03:57 AM
Very good, thanks for the appreciation and good luck!
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: