cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
702
Views
0
Helpful
5
Replies

FAX ISDN QSIG H323 E1 to E1 problem

dan.agache
Level 1
Level 1

Hello,

My solution is based on a Cisco 2821 Voice Gateway with two E1 interfaces (One connecting the PSTN and one for old PBX Ericsson). All my FAX machines are connected to old PBX and calls initiated from both sides works fine.

My problem is with FAX machines that can not receive or send faxes. They answer the calls, the send a short fax ton (40ms from debug), but the sending of the pages ends with "Error on Tx" message.

Can you give me a hint?

Here are my configuration parameters:

!

interface Serial0/1/0:15

description -- ERICSSON --

no ip address

encapsulation hdlc

isdn switch-type primary-qsig

isdn protocol-emulate network

isdn incoming-voice modem

no cdp enable

!

interface Serial0/1/1:15

description -- RTC --

no ip address

encapsulation hdlc

isdn switch-type primary-qsig

isdn incoming-voice modem

no cdp enable

!

dial-peer voice 108 pots

description -- to PSTN --

destination-pattern .T

fax rate voice

direct-inward-dial

port 0/1/1:15

forward-digits all

!

dial-peer voice 3 pots

description -- ERICSSON --

destination-pattern 20444..

fax rate voice

direct-inward-dial

port 0/1/0:15

forward-digits all

!

Thank you,

Dan

1 Accepted Solution

Accepted Solutions

paolo bevilacqua
Hall of Fame
Hall of Fame

Hi, likely you have not configured "network-clock-select 1 e1 0/1/1" so controller E1 is getting slips. Also check that controller E1 going to PBX should have clock source internal.

Note that the E1 going to PSTN should have switch-type primary-net5, although even qsign doen't make any difference in practice.

Hope this helps, please rate post if it does!

View solution in original post

5 Replies 5

paolo bevilacqua
Hall of Fame
Hall of Fame

Hi, likely you have not configured "network-clock-select 1 e1 0/1/1" so controller E1 is getting slips. Also check that controller E1 going to PBX should have clock source internal.

Note that the E1 going to PSTN should have switch-type primary-net5, although even qsign doen't make any difference in practice.

Hope this helps, please rate post if it does!

Hi,

and thank you for your answer and yours advises. I put the commands recommended by you, but this not helped. Can you tell what others think I missed making the faxes message to not be sent.

Many thanks.

Please send output of "show network-clocks" and "show controllers E1".

Hi,

I retake the teste and, after your commands, all works fine.

Thank you a lot,

Dan

Very good, thanks for the appreciation and good luck!

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: