Solved: Load balancing on ASA

shijomon scaria · ‎06-25-2008

Hello,

Can i load balance may traffic using single security appliance (ASA)

Thank YOu

a.alekseev · ‎06-25-2008

you can use the second link only as a backup link.

http://www.cisco.com/en/US/products/hw/vpndevc/ps2030/products_configuration_example09186a00806e880b.shtml

View solution in original post

balsheikh · ‎06-26-2008

Hi Gents,

but in this case ONLY one ISP is active at the time and the other is idle.

but if u require a load balance between two ISPs, I believe one more router needed to connect to the FW and configure a route-map for load balancing.

View solution in original post

a.alekseev · ‎06-25-2008

could you be more concrete.

What are you going to do?

shijomon scaria · ‎06-25-2008

Suppose i have an ASA in my netowrk, can i terminate two ISPs on my appliance? Also those connetions should provide load balancing in an active-active manner, if one goes down other should carry the entire traffic.. Is it is possible, if so Which among the ASA 5500 series will support these features..?

a.alekseev · ‎06-25-2008

you can use the second link only as a backup link.

http://www.cisco.com/en/US/products/hw/vpndevc/ps2030/products_configuration_example09186a00806e880b.shtml

balsheikh · ‎06-26-2008

Hi Gents,

but in this case ONLY one ISP is active at the time and the other is idle.

but if u require a load balance between two ISPs, I believe one more router needed to connect to the FW and configure a route-map for load balancing.