×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

How to change the IP address for the switch?

Unanswered Question
Collin Clark Wed, 06/25/2008 - 06:38
User Badges:
  • Purple, 4500 points or more

Assuming that the IP address is assigned to vlan 1,


config t

int vlan 1

ip address [new ip address] [netmask]


As soon as you hit enter, you'll lose management connectivity, but you should be able to connect to the new address. If you're changing management networks, you'll want to double check gateway/connectivity before making the change.


Hope that helps.

Ibbywannit Wed, 06/25/2008 - 06:40
User Badges:

If you are running a Layer 3 switch with the appropriate IOS then to assign an IP address to a specific port you would run the

"no switchport" command.


Actions

This Discussion