Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
491
Views
0
Helpful
4
Replies

HUM graphs

Go to solution
cmartinvalle
Level 1
Level 1

‎06-25-2008 07:44 AM

Hi,

I've configured some HUM collectors. When the collector is a standard one (CPU, memory, utilization, etc.) I can see the associated graphs but when I define a new collector (i.e., incoming traffic) I can see the data in a table but I cannot see the graph.

What do I have to do in order to watch these graphs?

Thank you very much.

Labels:
0 Helpful
1 Accepted Solution

Accepted Solutions

Go to solution
Joe Clarke
Cisco Employee
Cisco Employee
In response to cmartinvalle

‎06-25-2008 11:03 AM

You should be able to use the Histo-Graph It portlet, and generate a graph for any polled object on your device. Is this not working?

View solution in original post

0 Helpful
4 Replies 4

Go to solution
Joe Clarke
Cisco Employee
Cisco Employee

‎06-25-2008 07:54 AM

Where are you looking that you do not see graphs (i.e. the portal or a report)?

0 Helpful

Go to solution
cmartinvalle
Level 1
Level 1
In response to Joe Clarke

‎06-25-2008 10:30 AM

I'm looking in the portal. I can see the icon for launching graphs related to standard collectors but not for the ones that I create ad-hoc.

0 Helpful

Go to solution
Joe Clarke
Cisco Employee
Cisco Employee
In response to cmartinvalle

‎06-25-2008 11:03 AM

You should be able to use the Histo-Graph It portlet, and generate a graph for any polled object on your device. Is this not working?

0 Helpful

Go to solution
cmartinvalle
Level 1
Level 1
In response to Joe Clarke

‎05-04-2009 06:29 AM

OK, that works!

0 Helpful
Customers Also Viewed These Support Documents