Basic configuration for a WLAN Controller - 4400

Unanswered Question
Jun 25th, 2008
User Badges:

I've been reading over the "Cisco Wireless LAN Controller Configuration Guide, Release 4.0".

So it looks like once you have the HTTPS enabled and the management IP set, the majority of the configuration is through the GUI - clicking your way through all the settings.

I've never used a wireless LAN controller -- so to make this quick and easy, is it possible to make a "quick and dirty cut and paste" CLI template to get it up and running with just minimal settings left to be done?

If so, could you post it? Thanks.

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Scott Fella Wed, 06/25/2008 - 12:47
User Badges:
  • Super Silver, 17500 points or more
  • Hall of Fame,

    The Hall of Fame designation is a lifetime achievement award based on significant overall achievements in the community. 

  • Cisco Designated VIP,

    2017 Wireless

Well, first you will have to console into the wlc and go through the startup wizard. that is your minimum configuration to get it working. No way around this unless you build a script to automatically enter information on the startup wizard.


This Discussion