06-26-2008 07:37 AM - edited 03-03-2019 10:30 PM
I dont know if anyone can aid me here, I had a 2811 router which i couldnt remember the password on an so as you do i went into rommon mode and put in the confreg value... but i did the wrong value 0x0214 and now my router just prints jargon.. any ideas? :D
06-26-2008 09:45 AM
hi!
Can you try different baud rates? Jargon is usually printed when baud rates mismatch. dont know if this confreg value changed any of that... but just to chk....
06-26-2008 09:53 AM
Hi,
Nandrekar is right try to change the baud rate in hyper terminal and check will all possible values you will able to log in and change the reg value.
regards,
pravin
06-26-2008 11:27 AM
Hi There
Are you sure you set it to 0x0214? According to my notes, this confreg value should yield a baud rate value of 9600 as bits 11 & 12 are set to zero.
See http://www.cisco.com/univercd/cc/td/doc/product/access/acs_fix/cis2000/c2000qs/22812.htm
HTH
Best Regards,
Michael
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide