cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
295
Views
0
Helpful
3
Replies

Killing My Router...

hellspire69_2
Level 1
Level 1

I dont know if anyone can aid me here, I had a 2811 router which i couldnt remember the password on an so as you do i went into rommon mode and put in the confreg value... but i did the wrong value 0x0214 and now my router just prints jargon.. any ideas? :D

3 Replies 3

n.nandrekar
Level 4
Level 4

hi!

Can you try different baud rates? Jargon is usually printed when baud rates mismatch. dont know if this confreg value changed any of that... but just to chk....

Hi,

Nandrekar is right try to change the baud rate in hyper terminal and check will all possible values you will able to log in and change the reg value.

regards,

pravin

keeleym
Level 5
Level 5

Hi There

Are you sure you set it to 0x0214? According to my notes, this confreg value should yield a baud rate value of 9600 as bits 11 & 12 are set to zero.

See http://www.cisco.com/univercd/cc/td/doc/product/access/acs_fix/cis2000/c2000qs/22812.htm

HTH

Best Regards,

Michael

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: