cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
450
Views
0
Helpful
8
Replies

SRST doesn't work

webstd.design
Level 1
Level 1

Config

======================

isdn switch-type primary-4ess

!

voice-card 0

no dspfarm

!

!

voice translation-rule 1

rule 1 /74381/ /131/

rule 2 /743648/ /1304/

rule 3 /74380/ /130/

!

voice translation-rule 2

rule 1 /13/ /5367438/

!

!

voice translation-profile 1

translate called 1

!

voice translation-profile 2

translate calling 2

!

!

application

global

service alternate DEFAULT

!

!

!

controller E1 0/0/0

framing NO-CRC4

pri-group timeslots 1-31 service mgcp

interface Serial0/0/0:15

no ip address

encapsulation hdlc

isdn switch-type primary-net5

isdn overlap-receiving

isdn incoming-voice voice

isdn bind-l3 ccm-manager

isdn sending-complete

no cdp enable

access-list 111 deny tcp 10.XXXXX 0.0.0.255 host xxxx eq 2000

access-list 111 deny tcp 10.XXXXX 0.0.0.255 host xxxx eq 2000

access-list 111 deny tcp 10.XXXXX 0 0.0.0.255 host xxxx eq 2428

access-list 111 deny tcp 10.XXXXX 0 0.0.0.255 host xxxx eq 2428

access-list 111 deny udp 10.XXXXX 0 0.0.0.255 host xxxx eq 2427

access-list 111 deny udp 10.XXXXX 0 0.0.0.255 host xxxx eq 2427

access-list 111 permit ip any any

voice-port 0/0/0:15

translation-profile incoming 1

translation-profile outgoing 2

cptone RU

!

voice-port 0/1/0

!

voice-port 0/1/1

!

ccm-manager fallback-mgcp

ccm-manager redundant-host XXXX

ccm-manager mgcp

ccm-manager music-on-hold

ccm-manager config server XXXX

ccm-manager config

!

mgcp

mgcp call-agent XXXX 2427 service-type mgcp version 0.1

mgcp rtp unreachable timeout 1000 action notify

mgcp modem passthrough voip mode nse

mgcp package-capability rtp-package

mgcp package-capability sst-package

mgcp package-capability pre-package

no mgcp package-capability res-package

no mgcp package-capability fxr-package

no mgcp timer receive-rtcp

mgcp sdp simple

mgcp fax t38 inhibit

mgcp rtp payload-type g726r16 static

mgcp bind control source-interface GigabitEthernet0/1.10

mgcp bind media source-interface GigabitEthernet0/1.10

!

mgcp profile default

!

!

!

dial-peer voice 80 pots

incoming called-number .

direct-inward-dial

port 0/0/0:15

!

dial-peer voice 3 pots

tone ringback alert-no-PI

destination-pattern 80.........

no digit-strip

direct-inward-dial

port 0/0/0:15

!

dial-peer voice 4 pots

tone ringback alert-no-PI

destination-pattern 82.......

no digit-strip

direct-inward-dial

port 0/0/0:15

!

dial-peer voice 6 pots

tone ringback alert-no-PI

destination-pattern 0[0456789].

no digit-strip

direct-inward-dial

port 0/0/0:15

!

dial-peer voice 5 pots

tone ringback alert-no-PI

destination-pattern [23]....

no digit-strip

direct-inward-dial

port 0/0/0:15

!

dial-peer voice 7 pots

tone ringback alert-no-PI

destination-pattern 7.....

no digit-strip

direct-inward-dial

port 0/0/0:15

!

!

!

!

call-manager-fallback

max-conferences 8 gain -6

ip source-address XXXX port 2000

max-ephones 24

max-dn 48

transfer-pattern 0.

transfer-pattern 0..

transfer-pattern 2....

transfer-pattern 3....

transfer-pattern 7.....

transfer-pattern 82.......

transfer-pattern 80.........

keepalive 10

!

!

end

8 Replies 8

webstd.design
Level 1
Level 1

When I use ACL

access-list 111 deny tcp XXXX 0.0.0.255 host IPADDRESS_OF_CALLMANAGER1 eq 2000

access-list 111 deny tcp XXXX 0.0.0.255 host IPADDRESS_OF_CALLMANAGER2 eq 2000

access-list 111 deny tcp XXXX 0.0.0.255 host IPADDRESS_OF_CALLMANAGER1 eq 2428

access-list 111 deny tcp XXXX 0.0.0.255 host IPADDRESS_OF_CALLMANAGER2 eq 2428

access-list 111 deny udp XXXX 0.0.0.255 host IPADDRESS_OF_CALLMANAGER1 eq 2427

access-list 111 deny udp XXXX 0.0.0.255 host IPADDRESS_OF_CALLMANAGER2 eq 2427

access-list 111 permit ip any any

Phone registering on the gateway, but when I try to call nothing happens

debug voice translation

Jun 26 15:30:58.233: //-1/xxxxxxxxxxxx/RXRULE/regxrule_get_profile_from_trunkgroup_internal: Voice port 0x46546104 does not belong to any trunk group

Jun 26 15:30:58.233: //-1/B5877A80834B/RXRULE/regxrule_stack_pop_RegXruleNumInfo: stack=0x46B4C3A8; count=1

Jun 26 15:30:58.241: //-1/B5877A80834B/RXRULE/regxrule_stack_push_RegXruleNumInfo: stack=0x46B4C3A8; count=0

Jun 26 15:30:59.249: //-1/B5877A80834B/RXRULE/regxrule_stack_push_RegXruleNumInfo: stack=0x46B4C3A8; count=1

Jun 26 15:30:59.249: //-1/B5877A80834B/RXRULE/regxrule_dp_translate: No profile found in peer 7 for outgoing direction

Jun 26 15:30:59.249: //-1/B5877A80834B/RXRULE/regxrule_dp_translate: calling_number=1306 calling_octet=0x0

called_number=743807 called_octet=0x80

redirect_number= redirect_type=0 redirect_plan=0 redirect_PI=0 redirect_SI=0

Jun 26 15:30:59.249: //-1/B5877A80834B/RXRULE/regxrule_get_profile_from_voiceport_internal: Found profile 2 defined on voice-port

Jun 26 15:30:59.249: //-1/B5877A80834B/RXRULE/regxrule_profile_translate_internal: number=1306 type=unknown plan=unknown numbertype=calling

Jun 26 15:30:59.249: //-1/B5877A80834B/RXRULE/regxrule_profile_match_internal: Matched with rule 1 in ruleset 2

Jun 26 15:30:59.249: //-1/B5877A80834B/RXRULE/regxrule_profile_match_internal: Matched with rule 1 in ruleset 2

Jun 26 15:30:59.249: //-1/B5877A80834B/RXRULE/sed_subst: Successful substitution; pattern=1306 matchPattern=13 replacePattern=5367438 replaced pattern=536743806

Jun 26 15:30:59.249: //-1/B5877A80834B/RXRULE/regxrule_subst_num_type: Match Type = none, Replace Type = none Input Type = unknown

Jun 26 15:30:59.249: //-1/B5877A80834B/RXRULE/regxrule_subst_num_plan: Match Plan = none, Replace Plan = none Input Plan = unknown

Jun 26 15:30:59.249: //-1/B5877A80834B/RXRULE/regxrule_profile_translate_internal: xlt_number=536743806 xlt_type=unknown xlt_plan=unknown

Jun 26 15:30:59.249: //-1/B5877A80834B/RXRULE/regxrule_profile_translate_internal: number=743807 type=unknown plan=unknown numbertype=called

Jun 26 15:30:59.249: //-1/B5877A80834B/RXRULE/regxrule_get_RegXrule: Invalid translation ruleset tag=0

Jun 26 15:30:59.249: //-1/B5877A80834B/RXRULE/regxrule_profile_match_internal: Error: ruleset for called number not found

Jun 26 15:30:59.249: //-1/B5877A80834B/RXRULE/regxrule_profile_translate_internal: No match: number=743807 type=unknown plan=unknown

Jun 26 15:30:59.249: //-1/B5877A80834B/RXRULE/regxrule_profile_translate_internal: number= type=unknown plan=unknown numbertype=redirect-called

Jun 26 15:30:59.249: //-1/B5877A80834B/RXRULE/regxrule_get_RegXrule: Invalid translation ruleset tag=0

Jun 26 15:30:59.249: //-1/B5877A80834B/RXRULE/regxrule_profile_match_internal: Error: ruleset for redirect-called number not found

Jun 26 15:30:59.249: //-1/B5877A80834B/RXRULE/regxrule_profile_translate_internal: No match: number= type=unknown plan=unknown

Jun 26 15:30:59.249: //-1/B5877A80834B/RXRULE/regxrule_vp_translate: calling_number=536743806 calling_octet=0x0

called_number=743807 called_octet=0x80

redirect_number= redirect_type=0 redirect_plan=0

Jun 26 15:31:00.517: //-1/B5877A80834B/RXRULE/regxrule_stack_pop_RegXruleNumInfo: stack=0x46B4C3A8; count=2

Jun 26 15:31:02.773: //-1/xxxxxxxxxxxx/RXRULE/regxrule_get_profile_from_trunkgroup_internal: Voice port 0x46546104 does not belong to any trunk group

Jun 26 15:31:02.777: //-1/B83C4D2A834E/RXRULE/regxrule_stack_pop_RegXruleNumInfo: stack=0x46B4C0B4; count=1

Jun 26 15:31:02.777: //-1/B83C4D2A834E/RXRULE/regxrule_stack_push_RegXruleNumInfo: stack=0x46B4C0B4; count=0

Jun 26 15:31:04.557: //-1/B83C4D2A834E/RXRULE/regxrule_stack_pop_RegXruleNumInfo: stack=0x46B4C0B4; count=1

internal Number 1306 replaced by external 536743806. But this number doesn't see PRI

What number is being sent out of the PRI after the translation is done. What does debug isdn q931 say? Is this an incoming call or an outgoing call?

it is outgoing call.

debug isdn q931 saying nothing

when I try to call number from city

debug isdn q931 says that Destination is out of order

The debug says that you are dialing 743807. Is that what is being sent out of the PRI?

536743806 - it's needed number and it's good from debug voice translation

Can any body help me???? or no?

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: