CUCM 6.1 - How to set up System Speed Dials

Answered Question
Jun 26th, 2008
User Badges:
  • Silver, 250 points or more

Is there a way to build system speed dials in Call Manager 6.1?


I have a site that is wanting to have about 200 - 300 system speed dial numbers. Is this possible to do?


I could do this with translation patterns but did not know if there was something similar to setting up personal speed dials.


I do not want per phone basis, this needs to be something specific to this cluster.

Correct Answer by Chris Deren about 8 years 10 months ago

You can use either transaltion patterns (no canned way to bulk insert TPs unless you develop something in AXL), or use cti ports with dummy DNs (i.e. #XXX where XXX is the speed dial number) and set the call forward all to the desired destination, you can bulk insert cti ports.


HTH, please rate all posts!


Chris

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
Loading.
Correct Answer
Chris Deren Thu, 06/26/2008 - 10:19
User Badges:
  • Super Silver, 17500 points or more
  • Hall of Fame,
  • Cisco Designated VIP,

    2017 IP Telephony, Contact Center, Unified Communications

You can use either transaltion patterns (no canned way to bulk insert TPs unless you develop something in AXL), or use cti ports with dummy DNs (i.e. #XXX where XXX is the speed dial number) and set the call forward all to the desired destination, you can bulk insert cti ports.


HTH, please rate all posts!


Chris

Rick Morris Thu, 06/26/2008 - 10:28
User Badges:
  • Silver, 250 points or more

This is what I was afraid of...


dang it...maybe in version 7

Actions

This Discussion