ATA Question

Unanswered Question
Jun 26th, 2008

Hello,

Any help would be much appreciated.

Does anyone know how to configure an ATA to dial a number upon pick up ?

The ATA is interfaced with a Viking 1000-B board that is hooked up to a security gate intercom. Upon pushing the intercom button, I have managed to get a dial tone, bt need this to instead go to a specific extension.

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
jeffchilds Fri, 06/27/2008 - 05:17

Thanks alot.

I set up a new PLAR. It works great.

Thank you very much !!!

Jun Sarceno Thu, 03/28/2013 - 13:03

Hello, I am in the same situation as you. But a little less farther.  I have a Viking 1000B and W3000 system.  When I connect an analog phone line on the pin 4 and 5 of the Viking 1000B the phone rings.  But when I connect it to an ATA, the line 1 is automatically lit up as green as soon as I connect the phone line from the analog phone to the Cisco ATA 187.  Can you give assistance on you configured it before the PLAR?  Thanks

Actions

This Discussion