06-27-2008 02:18 AM
Dear All,
could you let me know!!!
i would like to ask you about pix 506E and i want to do VPN client and VPN site to site. i mean only one box this both VPN.
Do you have any simple configuration on this?
Please advice me!!! :)
Best Regards,
Join
06-27-2008 02:25 AM
Have a look at this:
http://www.cisco.com/en/US/products/ps6120/products_configuration_example09186a00807f9a89.shtml
http://www.cisco.com/en/US/products/ps6120/products_configuration_example09186a0080912cfd.shtml
Please rate helpful posts.
Regards
Farrukh
06-27-2008 07:16 PM
You have to configure first internet connectivity by simlet PAT,
global (outside) 1 {IP add}
NAT (inside) 1 (inside subnet)
Onc eit is done, access PDM if you have then configure IPsec by GUI.
http://www.cisco.com/en/US/products/ps6120/products_configuration_example09186a0080702992.shtml
Use same outside interface IP address for VPN client, You will save one IP address.
let me know if you need further help.
Thanks,
Dharmesh Purohit
06-29-2008 06:44 PM
Dear Farrukh,Dharmesh,
Thanks you for your advice, :)
Please see in the attach file. i configured VPN site to site already. and i would like to do one more VPN client but when i do VPN client the VPN site to site is down. this is PIX Version 6.3(5)
Could you advice some command on VPN client and VPN site to site.
Best Regards,
join
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: