AS 5350 OID's

Unanswered Question
Jun 27th, 2008

Hello everyone who is reading this thread.

I need to monitor E1-channel load("sh isdn status" command - active layer 3 calls). Found the following OID:,Y-port). Have 2 AS installed:

1st: Board Hardware Version 2.6,Board Revision C1 with E1 2 PRI

2nd: Board Hardware Version 2.7,Board Revision B0 E1 4 PRI).

On the first AS I'm getting the correct Counter value, on the other AS i'm getting decreasing in time large number.Should I make a TAC request? (couldn't find with snmpwalk even close value I need)

Thank in advance.

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)


This Discussion