Numbering Type

Unanswered Question
Jun 27th, 2008
User Badges:


I have set the numbering type to be unknown for my outgoing dial-peer but when i see the isdn debug i could see the numbering type is national and isdn plan

dial-peer voie 202 pots

numbering-type unknown

destination-pattern 2312144

port 0/1/0:15

forward-digits all

I am using my ip phone to dial a local number. I have created sip trunk and route pattern for 2312144.

The provider expects me to send unknown as numbering type for local calls.

Any suggestions

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Jaime Valencia Fri, 06/27/2008 - 05:45
User Badges:
  • Cisco Employee,
  • Hall of Fame,


use translation profiles

Number Translation using Voice Translation Profiles

Voice Translation Rules



if this helps, please rate

Paolo Bevilacqua Fri, 06/27/2008 - 05:47
User Badges:
  • Super Gold, 25000 points or more
  • Hall of Fame,

    Founding Member

You can set the numbering type under the isdn port:

isdn map address . plan unknown type unknown

rafi.imran Sat, 06/28/2008 - 23:40
User Badges:

I have only 1 E1 PRI..if i set this at this isdn port "unknown" would be set for all calls. I want this to be only for local landline calls. This type "unknown" should be set only for local landline calls and for all others national is required (set default by the router). This is the provider's requirement.

Paolo Bevilacqua Sun, 06/29/2008 - 08:00
User Badges:
  • Super Gold, 25000 points or more
  • Hall of Fame,

    Founding Member


I suggest you try "unknown" for all calls, chances are it will work despite what the SP says. If not, you will need multiple map statements or translation-rule to set different numbering type for each type of call.


This Discussion