HWIC Slots

Answered Question
Jun 27th, 2008

a real easy one i guess, I have a 2811 with the HWIC 0 - 3 slots, can i put a vic2fxo in there? I was told you could but no joy at the moment :) ta guys

I have this problem too.
0 votes
Correct Answer by Paolo Bevilacqua about 8 years 5 months ago

You are using a VIC-2FXO that not supported, as the router is telling you.

You need a VIC2-xFXO for the ISR routers.

As a recognition to whose providing answers, please rate useful posts!

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
Loading.
Paolo Bevilacqua Fri, 06/27/2008 - 06:11

Yes, but you also need a voice image and a minimum of PVDM2-8 to process voice.

Please rate post if it helps!

hellspire69_2 Fri, 06/27/2008 - 06:21

I have a PVDM2-64 and c2800nm-spservicesk9-mz.124-3i.bin image is this not sufficient? Im a tad noob at this ;)

hellspire69_2 Fri, 06/27/2008 - 06:25

Thanks:

WIC Slot 0:

FXO Voice daughter card (2 port)

WIC module not supported/disabled in this slot

Hardware revision 1.1 Board revision J0

Serial number 27623997 Part number 800-02495-01

FRU Part Number VIC-2FXO=

Test history 0x0 RMA number 00-00-00

Connector type Wan Module

EEPROM format version 1

EEPROM contents (hex):

0x20: 01 0D 01 01 01 A5 82 3D 50 09 BF 01 00 00 00 00

0x30: 98 59 52 00 01 11 07 01 FF FF FF FF FF FF FF FF

Correct Answer
Paolo Bevilacqua Fri, 06/27/2008 - 06:29

You are using a VIC-2FXO that not supported, as the router is telling you.

You need a VIC2-xFXO for the ISR routers.

As a recognition to whose providing answers, please rate useful posts!

Actions

This Discussion