06-27-2008 06:02 AM - edited 03-15-2019 11:35 AM
a real easy one i guess, I have a 2811 with the HWIC 0 - 3 slots, can i put a vic2fxo in there? I was told you could but no joy at the moment :) ta guys
Solved! Go to Solution.
06-27-2008 06:29 AM
You are using a VIC-2FXO that not supported, as the router is telling you.
You need a VIC2-xFXO for the ISR routers.
As a recognition to whose providing answers, please rate useful posts!
06-27-2008 06:11 AM
Yes, but you also need a voice image and a minimum of PVDM2-8 to process voice.
Please rate post if it helps!
06-27-2008 06:21 AM
I have a PVDM2-64 and c2800nm-spservicesk9-mz.124-3i.bin image is this not sufficient? Im a tad noob at this ;)
06-27-2008 06:23 AM
Do show diag and check if the voice card shows there. Report what it is exactly.
06-27-2008 06:25 AM
Thanks:
WIC Slot 0:
FXO Voice daughter card (2 port)
WIC module not supported/disabled in this slot
Hardware revision 1.1 Board revision J0
Serial number 27623997 Part number 800-02495-01
FRU Part Number VIC-2FXO=
Test history 0x0 RMA number 00-00-00
Connector type Wan Module
EEPROM format version 1
EEPROM contents (hex):
0x20: 01 0D 01 01 01 A5 82 3D 50 09 BF 01 00 00 00 00
0x30: 98 59 52 00 01 11 07 01 FF FF FF FF FF FF FF FF
06-27-2008 06:29 AM
You are using a VIC-2FXO that not supported, as the router is telling you.
You need a VIC2-xFXO for the ISR routers.
As a recognition to whose providing answers, please rate useful posts!
06-27-2008 11:22 AM
Sorry for the delay much respect for the help!! well appreciated.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: