nope still not working and here is the new config

can anyone else ping it?

I can ping your default-gateway ie. 68.213.152.81 but not .84

Can you ping the default-gateway from the pix ?

What does the ouput of a "sh int e0" on your pix show ?

Can you also temporarily remove

"static (inside,outside) 68.213.152.84 10.7.2.13 netmask 255.255.255.255 0 0"

from your config.

Jon

no i cannot ping the gateway from the pix

yes i can remove that line from the pix give me 2 min!

Sorry, just in case you missed it as i added it into previous post

"sh int e0"

Jon

AB01-CC-PIX(config)# sh int e0

interface ethernet0 "outside" is up, line protocol is up

Hardware is i82559 ethernet, address is 0013.6070.a868

IP address 68.213.152.84, subnet mask 255.255.255.248

MTU 1500 bytes, BW 100000 Kbit full duplex

384 packets input, 28890 bytes, 0 no buffer

Received 47 broadcasts, 0 runts, 0 giants

0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort

6 packets output, 360 bytes, 0 underruns

0 output errors, 0 collisions, 0 interface resets

0 babbles, 0 late collisions, 0 deferred

0 lost carrier, 0 no carrier

input queue (curr/max blocks): hardware (128/128) software (0/1)

output queue (curr/max blocks): hardware (0/1) software (0/1)

How is the pix connected to the router - is it via a switch/hub or a crossover cable ?

Do you have access to the router or is this managed by your ISP ?

Jon

the pic is connected to the dsl model via straight through cable

Just tried telnetting to default-gateway and it let me in. don't worry i logged straight out again - is this your ADSL router ?

Jon

yes the gateway is the dsl router witch is 81

84 is the pix 501

How are the 2 connected to each other. If it is via a switch then you need to make sure the switch ports are in the same vlan.

Jon

cable from port 1 of the modem to port 1 on the pix

When you say port 1 on the pix what is it labelled as - it needs to be eth0. Eth1 is the inside interface.

Jon