UC520 inbound calls to fxs port

Unanswered Question
Jun 27th, 2008

How can I route and inbound call to an fxs port? I want to route all calls to a specific number received on a fxo port to an fxs port.

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Paolo Bevilacqua Fri, 06/27/2008 - 12:36

Hi, fxo ports don't receive a called number.

So you use "connection plar opx xxx" where xxx is the extension, hunt-group pilot, or other number that you want all calls to be connected to.

Another good choice for an UC500 is to route to CUE AA number. The command is the same.

Please rate post if it does!


This Discussion