06-28-2008 11:58 PM - edited 03-05-2019 11:53 PM
Hi people,
I am getting the status from module1 is MinFail & for module2 is ok.
I think the Chasish crossed the minimum temperature am i right?
Message: module 1 inlet temperature crossed threshold #1=45C
Switch>sh module 1
Mod Ports Card Type Model Serial No.
--- ----- -------------------------------------- ------------------ -----------
1 48 48-port 10/100/1000 RJ45 EtherModule WS-X6148A-GE-TX SAL1103E6A3
Mod MAC addresses Hw Fw Sw Status
--- ---------------------------------- ------ ------------ ------------ -------
1 001a.a1a2.e610 to 001a.a1a2.e63f 1.5 8.4(1) 8.5(0.46)RFW MinFail
Mod Online Diag Status
---- -------------------
1 Pass
Switch>sh module 2
Mod Ports Card Type Model Serial No.
--- ----- -------------------------------------- ------------------ -----------
2 48 48-port 10/100/1000 RJ45 EtherModule WS-X6148A-GE-TX SAL1151AN2J
Mod MAC addresses Hw Fw Sw Status
--- ---------------------------------- ------ ------------ ------------ -------
2 001e.7af9.16b0 to 001e.7af9.16df 1.6 8.4(1) 8.5(0.46)RFW Ok
Mod Online Diag Status
---- -------------------
2 Pass
Experts can anybody plz. suggest me on this.
Regards,
Naidu.
06-29-2008 12:27 PM
Hello Naidu,
have someone check the cooling system for the rack.
Just to see if something changes you can open the rack door if any.
best regards
Giuseppe
07-02-2008 02:14 AM
Hi Giuseppe,
Thanx for your reply.
I am at remote location so i need to check with them.
Regards,
Naidu.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: