MGCP domain name configuration on CUSM 6.0(1)

Unanswered Question
Jun 29th, 2008
User Badges:

Hi dear,


in order to put the voice gateway hostname on MGCP domain gateway in CUSM administration interface..i need to put the entry:

- Voice Gw Hostname <-> IP address


Could you please help me to do it on CUSM 6.0(1)..


Thanks in advance

Best Regards

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Chad Stachowicz Sun, 06/29/2008 - 08:22
User Badges:
  • Silver, 250 points or more

if you have ip domain name set on the gateway..



use the FQDN on the hostname on CUCM (hostname.domain)


HTH, please rate useful posts..


Chad

Rob Huffman Sun, 06/29/2008 - 08:31
User Badges:
  • Super Red, 40000 points or more
  • Hall of Fame,

    Founding Member

  • Cisco Designated VIP,

    2017 IP Telephony, Unified Communications

Hi Mohamed,


Just to add a note to the great info from Chad;


The Domain name issue is outlined nicely in this doc;


MGCP Gateway Registration Failure with Cisco CallManager


http://www.cisco.com/en/US/products/sw/voicesw/ps556/products_tech_note09186a00805a316c.shtml#prob



If the IP domain name is configured in Cisco IOS on the MGCP gateway, enter the Fully Qualified Domain Name (FQDN) in the Domain Name field.


In the example: test and cisco.com represent the hostname and domain name respectively. If the IP domain name is not configured in Cisco IOS on the MGCP gateway, enter only the hostname of the MGCP gateway in the Domain Name field.


You would enter test.cisco.com (in CCM)



Hope this helps!

Rob



Jaime Valencia Sun, 06/29/2008 - 10:16
User Badges:
  • Cisco Employee,
  • Hall of Fame,

    2011

just to add to the great info make sure that you have the domain name in CUCM exactly as configured under the ip domain name command on the router, i ran into some cases in which the guys were lacking the .com on the domain or had something else and they thought it had the .com under the command and the GW would not register.


the fix is to just modify the entry where needed, add the .com on the GW or take the .com from the CUCM config


HTH


javalenc


if this helps, please rate

Actions

This Discussion