Called Party Transformation

Unanswered Question
Jun 29th, 2008
User Badges:

Some immediate help would be appreciated!


What I have is a CTI Port say ext. 5000

This is forwarding to a route point 7000.


In the route list I am sending it over a qsiq trunk.


Whenever I dial 5000, 7000 is presented as the called number.


I need to have 5000 presented as the called number.


Any help is appreciated.


  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Chad Stachowicz Sun, 06/29/2008 - 14:55
User Badges:
  • Silver, 250 points or more

Why are you doing it this way? Make sure what calling device you using to call 5000 has a Calling Search Space on the devices that has access to a partition containing a Route Pattern as 5000 with RL -> QSIG. The forwarding sounds unnecessary ?


HTH please share more if I'm missing something..


Chad

roboliveira Sun, 06/29/2008 - 15:15
User Badges:

The 5000 is a user DID that comes in over PRI. Wen that call comes in I need to send it over the QSIG to a siemens remote shelf.

If there is an easier way to do this I am open to any ideas.

Chad Stachowicz Sun, 06/29/2008 - 15:38
User Badges:
  • Silver, 250 points or more

ahh this is no problem..



Create a Partition


PT-Gateway-To-QSIG


then in the gateway CSS on the incoming PRI, make sure that Incoming CSS contains this partition in it).


now make 5000/PT-Gateway-To-QSIG Route Pattern and point it to RL-QSIG..



HTH, Please rate useful posts


Chad


PS/ (Be careful not to make a routing loop in the gateway, always double check Gateway CSS..)




Actions

This Discussion