6500 police/rate-limit egress

Unanswered Question
Jun 30th, 2008
User Badges:

I am trying to do an egress rate-limit on a 6500 Sup720/PFC3B 10/100 port. Everything I read seems to say it supports egress rate-limiting, but it will never let me bind a policy-map "output" on my interface. I am trying to rate-limit a 100Mbps interface to 10mbps/10Mbps. This is what I have so far. My ingress rate-limit seems to be working just fine. Any help would be greatly appreciated! Much Thanks....ahead of time.



access-list 100 remark QOS ACL For Rate-limiting Traffic

access-list 100 permit ip any any


class-map match-any limit_10Mb

description Rate-Limit 10Mb Ingress

match access-group 100


policy-map 10Mb_ingress

description Police 10Mbps Ingress

class limit_10Mb

police cir 10485500 bc 327671 be 327671 conform-action transmit exceed-action drop violate-action drop


interface FastEthernet4/29

switchport

switchport access vlan 136

switchport mode dot1q-tunnel

switchport nonegotiate

mtu 9216

no ip address

load-interval 30

l2protocol-tunnel cdp

no cdp enable

spanning-tree portfast

spanning-tree bpdufilter enable

service-policy input 10Mb_ingress


  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
eknell Tue, 07/01/2008 - 06:15
User Badges:

I apprecaite your help, but both GTS and CAR in the two links you sent me are for a layer3 interface.


I need to do egress rate limiting on a layer2 interface. Both the "rate-limit" and "traffic-shaping" commands are only allowed on a layer3 interface.


Do you happen to know somthing for layer2?


Thanks!

Pravin Phadte Tue, 07/01/2008 - 06:22
User Badges:
  • Silver, 250 points or more

Hi,


Sorry.


On layer 2 you can implement srr-queue


Its works a bit different:


Switch(config-if)# srr-queue bandwidth ?

limit -Configure bandwidth-limit for this interface

shape -Configure shaping on transmit queues

share -Configure shared bandwidth


below is the link for cisco 2690 switch.


http://www.cisco.com/en/US/docs/switches/lan/catalyst2960/software/release/12.2_44_se/configuration/guide/swqos.html#wp1163879


regards,


Pravin

eknell Tue, 07/01/2008 - 07:25
User Badges:

Pravin,


I actually use the "srr-queue bandwidth" command currently on some of my 3560G switch's and it works fine, but my 6500's seem to only support Weighted Round-Robin queuing?


I an running ver 12.2(18)SXF8 on Sup720-3B's?

Do you know if I can do anything with egress rate-limiting and the "wrr-queue bandwidth" command, because it won't let me set a limit and seems to only let me specify a weight to queue ratio.


Thanks for your help!

Actions

This Discussion