06-30-2008 11:06 PM - edited 03-05-2019 11:55 PM
I am doing routing on a stick. I have three subinterfaces defined in my router config. Sub1 = 10.10.1.0, Sub2 = 10.10.2.0, Sub3 = 10.10.3.0, and I am trunking between the router and the switch using dot1Q. My question is do I need to have a routing protocol to do intervlan routing or are these sub interfaces considered directly connected networks and therefore the routing protocol is not required? Thanks...AC
06-30-2008 11:15 PM
Hi Arnold
There is no requirement for a routing protocol to implement intervlan routing.
Best Regards,
Michael
07-01-2008 02:11 AM
Hi,
Michael said it right no need of routing protocols.
You too have said it right the interface ip address range will be directly connected.
Hope this helps,
Regards,
Pravin
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: