CLI on CME

Unanswered Question
Jul 1st, 2008
User Badges:

Hi,


I have a problem sending out my number when calling out via PSTN. How do I enable or configure CLI so that my main number will be displayed on the receiver's phone?


Your input will be highly appreciated.


Thanks


  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
Loading.
Paolo Bevilacqua Tue, 07/01/2008 - 00:50
User Badges:
  • Super Gold, 25000 points or more
  • Hall of Fame,

    Founding Member

Hi, there is more than one way.

The simpler one, under isdn interface, configure "isdn calling-number XXX".


Please rate post if it helps!

Paolo Bevilacqua Tue, 07/01/2008 - 02:44
User Badges:
  • Super Gold, 25000 points or more
  • Hall of Fame,

    Founding Member

Do "debug isdn q931" with "term mon" and check calling number as wll plan/type.

emmanuel.shoroma Tue, 07/01/2008 - 04:35
User Badges:

I can see it from the debug messages.


Jul 1 12:32:33.415: ISDN Se0/0/0:15 Q931: TX -> SETUP pd = 8 callref = 0x6CC0

Bearer Capability i = 0x8090A3

Standard = CCITT

Transfer Capability = Speech

Transfer Mode = Circuit

Transfer Rate = 64 kbit/s

Channel ID i = 0xA98381

Exclusive, Channel 1

Progress Ind i = 0x8183 - Origination address is non-ISDN

Calling Party Number i = 0x0180, '0126851300'

Plan:ISDN, Type:Unknown

Called Party Number i = 0x81, '0112089153'

Plan:ISDN, Type:Unknown

Paolo Bevilacqua Tue, 07/01/2008 - 04:40
User Badges:
  • Super Gold, 25000 points or more
  • Hall of Fame,

    Founding Member

Is 0126851300 your main number ?


If yes, ask telco if they want a plan/type set differently than ISDN/Unknown, as it is now.


If no, configure "isdn calling-number" with the right number.


Paolo Bevilacqua Tue, 07/01/2008 - 09:07
User Badges:
  • Super Gold, 25000 points or more
  • Hall of Fame,

    Founding Member

No problem, please remember to rate useful posts!

Actions

This Discussion