07-01-2008 12:24 AM - edited 03-17-2019 09:25 PM
Hi,
I have a problem sending out my number when calling out via PSTN. How do I enable or configure CLI so that my main number will be displayed on the receiver's phone?
Your input will be highly appreciated.
Thanks
07-01-2008 12:50 AM
Hi, there is more than one way.
The simpler one, under isdn interface, configure "isdn calling-number XXX".
Please rate post if it helps!
07-01-2008 01:15 AM
I tried it and still not working. what else can I try?
07-01-2008 02:44 AM
Do "debug isdn q931" with "term mon" and check calling number as wll plan/type.
07-01-2008 04:35 AM
I can see it from the debug messages.
Jul 1 12:32:33.415: ISDN Se0/0/0:15 Q931: TX -> SETUP pd = 8 callref = 0x6CC0
Bearer Capability i = 0x8090A3
Standard = CCITT
Transfer Capability = Speech
Transfer Mode = Circuit
Transfer Rate = 64 kbit/s
Channel ID i = 0xA98381
Exclusive, Channel 1
Progress Ind i = 0x8183 - Origination address is non-ISDN
Calling Party Number i = 0x0180, '0126851300'
Plan:ISDN, Type:Unknown
Called Party Number i = 0x81, '0112089153'
Plan:ISDN, Type:Unknown
07-01-2008 04:40 AM
Is 0126851300 your main number ?
If yes, ask telco if they want a plan/type set differently than ISDN/Unknown, as it is now.
If no, configure "isdn calling-number" with the right number.
07-01-2008 04:44 AM
thanks. will do
07-01-2008 06:21 AM
Thank you very much. it is now working. it was the telco problem.
07-01-2008 09:07 AM
No problem, please remember to rate useful posts!
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: