CLI on CME

emmanuel.shoroma · ‎07-01-2008

Hi,

I have a problem sending out my number when calling out via PSTN. How do I enable or configure CLI so that my main number will be displayed on the receiver's phone?

Your input will be highly appreciated.

Thanks

paolo bevilacqua · ‎07-01-2008

Hi, there is more than one way.

The simpler one, under isdn interface, configure "isdn calling-number XXX".

Please rate post if it helps!

emmanuel.shoroma · ‎07-01-2008

I tried it and still not working. what else can I try?

paolo bevilacqua · ‎07-01-2008

Do "debug isdn q931" with "term mon" and check calling number as wll plan/type.

emmanuel.shoroma · ‎07-01-2008

I can see it from the debug messages.

Jul 1 12:32:33.415: ISDN Se0/0/0:15 Q931: TX -> SETUP pd = 8 callref = 0x6CC0

Bearer Capability i = 0x8090A3

Standard = CCITT

Transfer Capability = Speech

Transfer Mode = Circuit

Transfer Rate = 64 kbit/s

Channel ID i = 0xA98381

Exclusive, Channel 1

Progress Ind i = 0x8183 - Origination address is non-ISDN

Calling Party Number i = 0x0180, '0126851300'

Plan:ISDN, Type:Unknown

Called Party Number i = 0x81, '0112089153'

Plan:ISDN, Type:Unknown

paolo bevilacqua · ‎07-01-2008

Is 0126851300 your main number ?

If yes, ask telco if they want a plan/type set differently than ISDN/Unknown, as it is now.

If no, configure "isdn calling-number" with the right number.

emmanuel.shoroma · ‎07-01-2008

thanks. will do

emmanuel.shoroma · ‎07-01-2008

Thank you very much. it is now working. it was the telco problem.

paolo bevilacqua · ‎07-01-2008

No problem, please remember to rate useful posts!