Hello I have a issue with spantree. This message appears
Jan 15 13:47:20.640 MEX: %SPANTREE-SP-7-RECV_1Q_NON_TRUNK: Received 802.1Q BPDU on non trunk GigabitEthernet1/1 VLAN7.
Jan 15 13:47:20.640 MEX: %SPANTREE-SP-7-BLOCK_PORT_TYPE: Blocking GigabitEthernet1/1 on VLAN0007. Inconsistent port type.
290052: Jan 15 13:47:25.028 MEX: %SYS-5-CONFIG_I: Configured from console by mnet onvty0 (172.18.0.120)
290053: Jan 15 13:48:11.584 MEX: %SYS-5-CONFIG_I: Configured from console by mnet onvty0 (172.18.0.120)
Jan 15 13:48:42.656 MEX: %SPANTREE-SP-2-BLOCK_BPDUGUARD: Received BPDU on port GigabitEthernet1/1 with BPDU Guard enabled. Disabling port.
Jan 15 13:48:42.656 MEX: %PM-SP-4-ERR_DISABLE: bpduguard error detected on Gi1/1, putting Gi1/1 in err-disable state
This occurs when I connect a Cat6500>SwitchAvaya>CatExpress 500.
Here are configured.
description "Hacia SW "
switchport access vlan 7
switchport mode access
no ip address
no cdp enable
You can see attachment.
I need to knows what do I can configured to this work well?.
Can you help me?.
Spanning tree portfast is not recommended for switch to switch links.
If you want to continue using this port as access port, then disable bpduguard on interfce:
spanning-tree bpduguard disable