07-02-2008 09:31 AM - edited 03-15-2019 11:42 AM
have voicemail XXXX in call-manager fallback. When in SRST, gets fast busy when hit messages button. Also cannot dial internal 4 digit extensions, which I suspect is related. Any help is appreciated.
07-02-2008 09:58 AM
please post the whole config, is the VM going to be reached thru PSTN or is it local?
HTH
javalenc
if this helps, please rate
07-02-2008 11:26 AM
VoiceMail is local. Here is the dial-peer and call-manager-fallback.
dial-peer voice 1 pots
description Outbound SRST LD
destination-pattern 91..........
port 2/0:23
prefix 1
!
dial-peer voice 3 pots
description Outbound SRST Intl
destination-pattern 9011............
port 2/0:23
prefix 011
!
dial-peer voice 6020 voip
session target ipv4:172.19.64.130
incoming called-number .
dtmf-relay h245-alphanumeric
no vad
!
dial-peer voice 4 pots
description Outbound 10 Digit Local
destination-pattern 9[2-9].........
port 2/1:23
!
dial-peer voice 5 pots
description Inbound
incoming called-number .
direct-inward-dial
port 2/1:23
!
dial-peer voice 6 pots
incoming called-number .
direct-inward-dial
port 2/0:23
!
!
!
call-manager-fallback
secondary-dialtone 9
max-conferences 8 gain -6
transfer-system full-consult
ip source-address X.X.X.X port 2000
max-ephones 200
max-dn 200 dual-line
system message primary phone system in Backup Mode
dialplan-pattern 1 3234366... extension-length 4 no-reg
dialplan-pattern 2 3234366... extension-length 4 no-reg
voicemail 3000
call-forward busy 3000
call-forward noan 3000 timeout 4
time-zone 5
date-format dd-mm-yy
07-02-2008 12:24 PM
if the VM is local you need to configure CME and the VM ports to register locally, also the VM system to failover to the CME if primary fails
HTH
javalenc
if this helps, please rate
07-02-2008 12:26 PM
CM is remote, version 4.2.3,
Unity is local, v4.2.1
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide