no display for 7914 expansion module

Unanswered Question
Jul 3rd, 2008

i'm using cme 4.1 and i've connected 7914 to a 7961 phone. i have defined correct loads and also under the phone i have added it as a addon.

the problem is a continuos red light on 7914 and no display is coming on the module. i can ring the extension given to the module from other phones

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Paolo Bevilacqua Thu, 07/03/2008 - 12:15

Hi, you need to configure the module as type under ephone, copy the firmware file S001xxxx.bin in flash, configure load 7914 as baove file without the .bin extension, and configure tftp-server for the above file.

Without all these steps, the module will not work.

Please rate post if it helps!

mohamedrishin Fri, 07/04/2008 - 09:44

yes all tat was done by me. i can ring the extension assigned to it.but no display is coming.thats the problem

also i did with an extension of .sbn not .bin right???

and the file was s105000200.sbn

Paolo Bevilacqua Sat, 07/05/2008 - 11:54

Yes, .sbn If you do "debug tftp events" with "term mon" you should see the file request coming from the phone and if the file is found.


This Discussion