07-04-2008 06:42 AM - edited 03-15-2019 11:44 AM
Hi,
I'm implementing a Callmanager express for a client and i'm experiencing a problem. I configured speed dial on a 7961 IP phone. The speed dial shows agains some of the botton on the phone and does not show on other botton. Despite the same commands for all bottons. What could probably be the cause? Pls help.
07-04-2008 07:31 AM
Hi, speed-dial will show only if you have free unused buttons, and the number used does NOT define the button that will be used, is that your case ?
07-04-2008 07:34 AM
Hi Peternnaji,
How are you programming CME? Through the console or web interface?
Try doing this with the web interface. It's much easier.
HTH, Please vote below for my post.
Regards,
Justin Brenton
07-04-2008 07:42 AM
I'm programming thriugh console but how do i go into the web interface?
07-04-2008 09:34 AM
Hi friend,
Check this link to enable the GUI for CallManager Express:
http://www.cisco.com/en/US/docs/voice_ip_comm/cucme/admin/configuration/guide/cmegui.html
Hope this helps a little bit.
Regards,
-- Adrián.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: