paolo bevilacqua Fri, 07/04/2008 - 08:54
User Badges:
  • Super Gold, 25000 points or more
  • Hall of Fame,

    Founding Member

First one was configured in nvram at startup.

Second one has been configure manually with in a config session.


Really what the router says :)



paolo bevilacqua Fri, 07/04/2008 - 15:13
User Badges:
  • Super Gold, 25000 points or more
  • Hall of Fame,

    Founding Member

Are you familiar with the concept of "startup configuration" and "config term" in IOS ?



Edison Ortiz Fri, 07/04/2008 - 17:15
User Badges:
  • Super Bronze, 10000 points or more
  • Hall of Fame,

    Founding Member

As Paolo stated, when you see an interface listed with Manual it means the IP address was configured on that interface after the router was rebooted.


For instance:


Router(config)#int s0/0

Router(config-if)#ip add 192.168.1.1 255.255.255.0

Router(config-if)#no shut

Router(config-if)#end

Router#sh ip int bri

*May 10 11:42:49.843: %SYS-5-CONFIG_I: Configured from console by console

Interface IP-Address OK? Method Status Protocol

Serial0/0 192.168.1.1 YES manual up up


Now, if I reboot the router, the interface chances to NVRAM.



Router#sh ip int bri

Interface IP-Address OK? Method Status Protocol

Serial0/0 192.168.1.1 YES NVRAM up up



HTH,


__


Edison.


Please rate helpful posts


Actions

This Discussion