I have set up a LWAPP network for a hospital running all "A" with some hotspots that are "G" capable. Because of interference issues in the hospital I have disabled the "G" radio in all the access points that are not part of the hotspot areas. However, by doing this I can no longer see the RF Heat maps of these APs in the WCS.
Does anyone know how to display the RF Heat Maps for APs that only have the "A" radio enabled? As it stands right now, if I look at a map in the WCS I only see the RF Heat map for the APs that have the "G" enabled.
Any help will be greatly appreciated!
When you have the map showing, there is a layers tab above the map, click on access point and then choose 802.11a/n for the protocol. That should do it for you.