Etherswitch question

Answered Question
Jul 7th, 2008
User Badges:
  • Bronze, 100 points or more

I noticed cisco says that if 2 etherswitches are in the same router chassis that they must be stacked.


so is the NM-1GE considered an etherswitch?


I was planning on putting both the NM-1GE and NME-16ES-1G in the same router would this require stacking (thus making the NM-1GE useless) or is this a valid setup?

Correct Answer by paolo bevilacqua about 8 years 9 months ago

No, the NM-1GE is not, and is not considered, an etherswitch.


Note that depending on the router where you're placing it, the routing performances for NM-1GE can be much, much less than wire rate.


Please rate post if it helps!

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (3 ratings)
Loading.
Correct Answer
paolo bevilacqua Mon, 07/07/2008 - 05:52
User Badges:
  • Super Gold, 25000 points or more
  • Hall of Fame,

    Founding Member

No, the NM-1GE is not, and is not considered, an etherswitch.


Note that depending on the router where you're placing it, the routing performances for NM-1GE can be much, much less than wire rate.


Please rate post if it helps!

is66rlhntadm Mon, 07/07/2008 - 06:02
User Badges:
  • Bronze, 100 points or more

Thanks thats what I thought but I wanted to be sure


I'm planning to put it in a 3745

Actions

This Discussion