Problem with FXO card

Unanswered Question
Jul 7th, 2008
User Badges:

Hi, i have a CCM 6 and Unity Connection 2.0 with IVR,all work fine, but i try to connect the lines of the old PBX to FXO card, but when i try to call the line ringing but dont send to IVR.


This is part of the configuration


voice-port 0/2/2

timeouts call-disconnect 2

connection plar opx 3022

description Linea 3265323

caller-id enable


This gateway is configured in H323


Thanks regards,


Carlos


  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Jaime Valencia Mon, 07/07/2008 - 12:43
User Badges:
  • Cisco Employee,
  • Hall of Fame,

    2011

do you already have a dial peer for 3022 and that DN configured in CUCM to go to VM??


HTH


javalenc


if this helps, please rate

cvicentep Mon, 07/07/2008 - 12:55
User Badges:

The configuration of dial-peer is :


dial-peer voice 550 voip

destination-pattern *32T

session target ipv4:172.16.4.1

incoming called-number ....

dtmf-relay h245-alphanumeric

codec g711alaw

ip qos dscp cs5 media





Jaime Valencia Mon, 07/07/2008 - 13:11
User Badges:
  • Cisco Employee,
  • Hall of Fame,

    2011

does it work if you change it to?:


destination-pattern 32..


HTH


javalenc


if this helps, please rate

cvicentep Mon, 07/07/2008 - 13:25
User Badges:

i change taht and nothing.


but i execute this comand :


GW#sh voice port 0/2/2


Foreign Exchange Office 0/2/2 Slot is 0, Sub-unit is 2, Port is 2

Type of VoicePort is FXO

Operation State is DOWN

Administrative State is UP

The Last Interface Down Failure Cause is Administrative Shutdown

Description is Linea 3265323



and appear that.



Jaime Valencia Mon, 07/07/2008 - 14:36
User Badges:
  • Cisco Employee,
  • Hall of Fame,

    2011

then go to voice port config and do a shut / no shut


HTH


javalenc


if this helps, please rate

Actions

This Discussion