Problem with FXO card

cvicentep · ‎07-07-2008

Hi, i have a CCM 6 and Unity Connection 2.0 with IVR,all work fine, but i try to connect the lines of the old PBX to FXO card, but when i try to call the line ringing but dont send to IVR.

This is part of the configuration

voice-port 0/2/2

timeouts call-disconnect 2

connection plar opx 3022

description Linea 3265323

caller-id enable

This gateway is configured in H323

Thanks regards,

Carlos

Jaime Valencia · ‎07-07-2008

do you already have a dial peer for 3022 and that DN configured in CUCM to go to VM??

HTH

javalenc

if this helps, please rate

HTH

java

if this helps, please rate

cvicentep · ‎07-07-2008

The configuration of dial-peer is :

dial-peer voice 550 voip

destination-pattern *32T

session target ipv4:172.16.4.1

incoming called-number ....

dtmf-relay h245-alphanumeric

codec g711alaw

ip qos dscp cs5 media

Jaime Valencia · ‎07-07-2008

does it work if you change it to?:

destination-pattern 32..

HTH

javalenc

if this helps, please rate

HTH

java

if this helps, please rate

cvicentep · ‎07-07-2008

i change taht and nothing.

but i execute this comand :

GW#sh voice port 0/2/2

Foreign Exchange Office 0/2/2 Slot is 0, Sub-unit is 2, Port is 2

Type of VoicePort is FXO

Operation State is DOWN

Administrative State is UP

The Last Interface Down Failure Cause is Administrative Shutdown

Description is Linea 3265323

and appear that.

Jaime Valencia · ‎07-07-2008

then go to voice port config and do a shut / no shut

HTH

javalenc

if this helps, please rate

HTH

java

if this helps, please rate