Buy or Renew
Buy or Renew
Cisco Virtual Engineer generative AI bot now active in Wireless Discussion Forum. Learn more.
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
1249
Views
5
Helpful
3
Replies

WLC: Configuring Global Credentials for Access Points

simonbaumann
Level 1
Level 1

‎07-07-2008 10:54 PM - edited ‎07-03-2021 04:08 PM

Hi,

I have an WLC 4404 running Software Version 5.0.148.0 with 40 LWAPPs (1242AG, some 1231G). I want to configure global credentials for the LWAPPs. The configuration guide did not mention, if I have to reboot the LWAPPs after setting the credentials.

So, could I set this option during operation time? Thanks a lot for your help.

Regards

Simon

Labels:
0 Helpful
3 Replies 3

Scott Fella
Hall of Fame
Hall of Fame

‎07-08-2008 03:45 AM

If you want to create a username and password for your LAP's then enter this command:

config ap username password

-Scott
*** Please rate helpful posts ***
0 Helpful

jeromehenry_2
Level 3
Level 3

‎07-08-2008 04:26 AM

Hi,

Configuring the "Override global credentials" option in the GUI does not reboot the AP. It can be done in a production environment, just did it on one of my 1252s to test.

Hope it helps.

Jerome

simonbaumann
Level 1
Level 1
In response to jeromehenry_2

‎07-08-2008 05:44 AM

It's working fine. Thanks for your help.

0 Helpful
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Customers Also Viewed These Support Documents
Review Cisco Networking products for a $25 gift card