07-08-2008 02:12 AM - edited 03-06-2019 12:03 AM
Hi,
Can any one help on this, if the network consists of 2 core switches and 10+ distribution switch, is it feasible to configure the VLANs in distribution switch. Whcih is the best config to do when designing a VLAN.
Is it good to keep the VLANs under core switch or distribution switch.
07-08-2008 03:05 AM
Not knowing ur full requirement, I will give a generic response.
I usually try to seperate VLANs from access to cross to core. so, I use access vlans on access switches , then route back to core switch on over one uplink VLAN.
HTH
Sam
07-08-2008 03:15 AM
That means no vlans are entering into core switch. In that case where can we run the HSRP.
07-08-2008 03:33 AM
Are u planning in terminating ur vlans on access switches. what I have in mind is :
ACC_SW01==CUST==ACCSW02, all on same VLAN, then you can run HSRP on access switches.
Please add more info on your requirement, so we can help you better.
HTH
Sam
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: