07-08-2008 02:46 AM - edited 03-13-2019 05:26 PM
Hi I am having problems getting through to the CUE on my UC500. The calls are reaching the dial peer but failing with network problems. I would be greatfull for any help. I have attached the configs and the output of a show dial peer. I am aware the CME is lacking a full config but I have got hung up on this. I have been banging my head against this for 2 days now please help.
07-08-2008 09:18 PM
Check if you have consistent IP address in Service-engine 0/0 it is x.x.41.1 but in
dial-peer 10.0.40.1
interface Integrated-Service-Engine0/0
ip unnumbered Loopback0
service-module ip address x.x.41.1 255.255.255.0
service-module ip default-gateway x.x.41.254
in the dial peer
session-target = `ipv4:10.0.40.1'
Please rate if this is it.
07-08-2008 11:29 PM
Very good catch but I am still having the same problem. Goes to engaged tone.
Debug is
uccessful Calls = 0, Failed Calls = 6, Incomplete Calls = 0
Accepted Calls = 0, Refused Calls = 0,
Last Disconnect Cause is "26 ",
Last Disconnect Text is "network out of order (38)",
I can get in through the service menu on the phone, but not if it is dialed.
07-09-2008 02:09 AM
Managed to get it up by reloading the firmware. Something must of gone a bit buggy.
Thanks for your help though. I hate typos and they can take forever to find.
07-09-2008 03:58 AM
Glad I can help. Please rate the post.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: