07-08-2008 07:36 AM
I'm planning to route some traffic while loadbalancing other traffic.
For guidance, what can I refer for simple routing in ACE.
In addition, both routing and loadbalancing traffics need to pass a same Vlan in the ACE.
In the attached Steps 1,2,3 doing loadbalancing via vlan80
Steps 4,5,6 doing routing via same VLAN 80
Is simple routing possible in ACE?
Regards
SS
Solved! Go to Solution.
07-08-2008 08:29 AM
as long as you permit the traffic with an access-list inside the access-group, ace will route the traffic that does not match any class-map.
This is the default and no particular config is required.
Gilles.
07-08-2008 07:44 AM
07-08-2008 08:29 AM
as long as you permit the traffic with an access-list inside the access-group, ace will route the traffic that does not match any class-map.
This is the default and no particular config is required.
Gilles.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: